DSP Robotics Support

Hello gang,

In this simple schematic when the two pulses cross each other (by varying the delays) how could I make them just pass each other without adding. Many thanks if you can solve it, BobF.....

Simplest way is to clip the output to limit the range.

Cheers

Spogg

Thanks Spogg,

But I for got to mention (very sorry), this is not the actual circuit so clipping will not work. The actual circuit is a new filter I am working on with 2 resonant peaks, but it has a way to go still before I post it.

Later then, BobF.....

In that case, since the additive effect is a mathematical certainty, I would say you need a fast compressor/limiter to keep the amplitude level. Based on your example I would say a peak-based envelope follower would be best, rather than average or rms.

Cheers

Spogg