DSP Robotics Support

Hi,

I would like to have my knob values kind of go up in a slope instead of linear how it is now. Hard to explain so I tried visualizing it with a picture.



Does anybody have any ideas how to approach this?

Thanks!

You need “mappers”. These provide a transfer function from input to output.

I’ve included those I regularly use in the schematic. The Log knob and 0-1 with mid were made by Martin Vicanek.

Also I've included a 0-1 stream version which is useful for defining an ouptput range, for example for key-tracking. They all need a 0-1 input range.

When you click on the P you can enter the values you want for the output.

Cheers

Spogg

True hero Spogg! Thank you so much

Spogg wrote:You need “mappers”. These provide a transfer function from input to output.

I’ve included those I regularly use in the schematic. The Log knob and 0-1 with mid were made by Martin Vicanek.

Also I've included a 0-1 stream version which is useful for defining an ouptput range, for example for key-tracking. They all need a 0-1 input range.

When you click on the P you can enter the values you want for the output.

Cheers

Spogg