DSP Robotics Support

When I try to load my own knob, even if I set the right pixel size the knob doesn't work; it just goes around in all directions. Also, I don't see all the options I should see when I watch tutorials on YouTube, I just have a limited set of options in my Animeted Knob module. Any idea why? I've uploaded my file so you can check it out.

Your sweep angles are wrong, in the knob ruby code change it to this:

@startAngle = 0
@sweepAngle = 360

adamszabo wrote:Your sweep angles are wrong, in the knob ruby code change it to this:

@startAngle = 0
@sweepAngle = 360

Thanks! It worked!