Page 1 of 1
Using knobs to change Waveforms.
Posted: Sat Nov 28, 2015 5:50 pm
by Halon
Hi Flowstoners!
Was wondering if there is a way to use a knob to change the Waveforms of the Oscs and LFOs. I've tried a lot of things, but cant seem to figure it out.
Cheers.
Re: Using knobs to change Waveforms.
Posted: Sat Nov 28, 2015 7:42 pm
by BobF
Hello Halon,
Do a search on morph/ing. Also most of the oscillators here just put out sine, triangle, saw, and square as basic waveforms. You would then pass them through wave shapers or most of the time a filter. Do a searh for shaper/s, fuzz, distoration, and etc..
Good luck, BobF.....
Re: Using knobs to change Waveforms.
Posted: Sat Nov 28, 2015 8:30 pm
by Halon
BobF wrote:Hello Halon,
Do a search on morph/ing. Also most of the oscillators here just put out sine, triangle, saw, and square as basic waveforms. You would then pass them through wave shapers or most of the time a filter. Do a searh for shaper/s, fuzz, distoration, and etc..
Good luck, BobF.....
Thanks Bob.