D flip flop
Posted: Tue May 05, 2015 8:14 pm
Hello gang,
Here is another module I created, the D type Flip Flop with a demo of one use for it. A divide by 2 for square waves (It will take a sine or triangle also , but acts a little different with saws and ramps). It acts very much like a real TTL D Flip Flop for those familiar with TTL logic hardware. It only outputs from 0 to 1 square waves. There are comments inside the FSM, so please read it for more information. *** Some feedback would really be appreciated.
Comments, suggestions, improvements, uses, and etc. are always welcome. If anyone has any ideas on optimizing this I would really like to hear from you. If used for commercial use though, please contact me.
Later then, BobF.....