Page 1 of 1
Undo and automation.
Posted: Wed Oct 10, 2018 8:16 am
by lalalandsynth
Is it possible to have a parameter un-doable without it showing up in the Automation parameters ?
I am using the Advanced envelope and in order to have it undoable it needs to show up in the automation parameters and its 64 parameters , completely redundant and bloats the automation list.
Is this possible somehow , is there something I am overlooking ?
Re: Undo and automation.
Posted: Wed Oct 10, 2018 9:02 am
by Spogg
I don’t think it’s possible, in Reaper anyway. I believe you can hide the individual array parameters though in Reaper.
I would expect any solution would be in the DAW rather than FlowStone.
Cheers
Spogg
Re: Undo and automation.
Posted: Wed Oct 10, 2018 11:29 am
by lalalandsynth
But a lot of plugins do this though , like in this example where I might have 64 points in an envelope, I dont want all these 64 points to show up in the automation list , no need to automate them in any event and they bloat the list.
Re: Undo and automation.
Posted: Wed Oct 10, 2018 11:56 am
by Spogg
Interesting.
Just a thought... Have you tried un-ticking "Auto" in the preset parameter module?
Cheers
Spogg
Re: Undo and automation.
Posted: Wed Oct 10, 2018 12:03 pm
by lalalandsynth
Would you believe me if I told you ....no .
hehe lol
I will test it.
Re: Undo and automation.
Posted: Thu Oct 11, 2018 10:17 am
by lalalandsynth
I will have to test it but I seem to recollect that if I set auto to False then it is not undoable.