Knob ratio : Compressor

[rustyou]

Hello !

I have a question,

what is a value of knob ratio (0 - 1) of output : 1:1 ....etc

Exemple knob position 0 = 1:1
knob position (max) 1 = 8:1

How see the reference ??


Thank you

[Perfect Human Interface]

Hello, I'm not sure exactly what you're asking for, but I added an output to my knobs for the 0-1 ratio as well as the set min/max ratio. Maybe something like that will help you? Or you could just set the knob to 0-1 and then multiply by 7 and add 1 outside of the knob.

[rustyou]

Hi !

Ex :

How to define three position for my knob :

1:1
2:1
4:1

For this exemple, what is the value for my knob.

limit knob : 0min and max 1

Thx u

[tester]

Knob outputs just values, whether these represent ratios or something/anything else. You just set the min/max from 1 to N, and you have ratios, for example from 1:1 to N:1.

If you wish to have specific numbers - you can use a selector driven by knob out or if-then-else routine or some sort of down/up rescaling with integers, if this is supposed to be infinite range of regularly defined ratios.

[rustyou]

Thank


In out meter monitor.

My compressor will be of knob = 5 --------> out monitor compress = 5:1 value ? exactly ?

[tester]

Now, connecting second wire to your compressor - remember to scale your green value (on that second wire) appropriately to input requirements of your compressor part, to fit proper ranges there.

[rustyou]

Eh ...

For this exemple of compressor.

The value of ratio is : min =0 max=1

What the real value in output (1:1, 2:1...etc)


0 = 1:1
0.5= ?
1=?...

Thank you,